Access Denied
IMPORTANT! If you’re a store owner, please make sure you have Customer accounts enabled in your Store Admin, as you have customer based locks set up with EasyLockdown app. Enable Customer Accounts
Accessories
Installation & Use
What is the 16V PD injector fitting kit designed for?
The fitting kit complements the installation of the 07eins 16V PD injector bridge as well as work on compatible, double-bolted BOSCH PD injectors. It includes gasket sets, rocker arm bolts and threadlocker.
What does the 16V PD injector fitting kit contain?
The set contains five M8 × 56 rocker arm bolts, four BOSCH seal sets or repair kits, and a screw locking compound in a dosing syringe. Reinforced 07eins VITON seals are not included in this individual fitting set.
Where is the supplied threadlocker used?
Use the supplied threadlocker for the screws on the PD injector bridge or PD injector retainer specified in the installation instructions. This approval applies to these specific assembly points and must not be extended to other engine screws.
When do I need the 16V overhaul screw set?
The kit is intended for the reassembly of an existing 07eins 16V PD injector bridge. It becomes relevant when the bridge has been removed, for example, for a PDE service, new seals, diagnostics or work on the cylinder head.
What does the 16V overhaul screw kit contain?
The overhaul kit contains the bolts and washers listed in the product description for reassembly. A complete 16V PD injector bridge is not included: the connecting bar, retaining brackets and adjustment plates remain part of the existing bridge. You will need to supply seals, rocker arm bolts and threadlocker separately if required.
Why are new bolts needed for reassembly?
When tightened, bolts are subjected to stress and may stretch. For reassembly, removed stretch bolts in particular are replaced with new ones. Which bolts need to be replaced is determined by the relevant assembly instructions.
Why does the 16V PD injector bridge require M6 × 95 injector bolts?
07eins’s M6 × 95 injector bolts are designed to fit the additional component geometry of the 16V PD injector bridge. Standard injector bolts, or those that are too short, must not be reused in this fitting position.
Service & further enquiries
Which documents fit in 07eins Papersave?
Papersave has room for the registration certificate Part I and up to two additional cards, such as a driving licence and an identity card. It can hold three documents in total.
How many cards fit in the 07eins Slim Wallet?
The Slim Wallet holds up to 18 cards. With the coin compartment inserted, it holds up to 14 cards. Banknotes are secured with the external money clip.
Invalid password
Enter